2100-A16 (Analogue Input Remote Station)

Stand Alone logging option

Memory Expansion Features:

• Comms; RS232 or RS422.
• Selectable sample rate;
  2, 5, 30 sec, 1, 2, 5, 10, 15, 30 min, 1 hour.
• Samples stored in permanent memory.
• Rolling buffer (first in first out).
• Upload to Intech scada software via;
  • standard comms,
  • radio or telephone modem.
• Memory; 32,000 samples.
• Each sample contains 26 readings, consisting of;
  • 16 analogue input values
  • 2 analogue output values
  • 4 digital input state
  • 2 digital output state
  • 1 ambient temperature
  • 1 time and date of sample

Ordering Information:

Supplied included with the 2100-A16 (ready to operate):

Supplied seperately (for retro-fitting to the 2100-A16 - see installation guide above for instructions):

2100-ME-32

Notes:

1. Only fit 2100-ME-32 to 2100-A16 Rev.1 RTU-32 or 2100-A16 Rev1.2
2. The clock of the 2100-ME is operated by a supercap. The clock will be retained for typically 2 weeks with no power. When the power is re-applied the supercap recharges itself.
3. Sample transfer rate of the flash memory is more than 300 samples/minute at 9600baud. The 2100-ME-32 takes approx. 104 minutes to upload.
4. When samples are taken, only the spot values at that time are stored.
5. The 2100-ME can be used when the PLC retransmission modes and Scada COMMS are operating. However, either the Scada must be stopped to read the samples out of the memory, or a seperate port must be used.
6. The 2100-R cannot be used when the 2100-ME is installed.
7. 2100-M values are not stored. The 2100-M driver does not operate with the 2100-ME installed.
8. The 2100-ME cannot be used with RS485 Comms.
9. 2100-ME Memory Board CANNOT be used when Modbus RTU protocol is used.